1331 Lincoln Hwy,

Levittown, PA. 19056

Mon-Sat 7:00am-7:00pm

Sunday 10:00am-6:00pm

Mon-Sat 7:00am-7:00pm

Sunday 10:00am-6:00pm

1331 Lincoln Hwy,

Levittown, PA. 19056

Clogged Kitchen Sink? 6 Sure & Easy Ways To Help Unclog

Clogged kitchen sinks are amongst the most common drain concerns that homeowners deal with. Fortunately, clogged drains are as well just one of the most basic home repair work to perform on your own.

When it comes to the kitchen’s sink, do not think Drano or other chemical-based drain cleaners are the quick solutions. Even though the blockage seems cleared, the chemicals can often do even more damage to your system.

Don’t think of calling the local plumber ! There’s a likelihood you can fix the problem yourself with just one of these 6 kitchen’s sink unclogging approaches:

1. Attack with boiling water

When hair, grease, soap residue, and other debris become blocked in your drain, boiling water might be all that is required to clear the obstruction. It’s the most convenient service, thus it must be your first choice when attempting to unblock a sink.

Here are the actions to take, which are as simple as 1-2-3:

 

  • Bring half a gallon of water to a boil on the stove, or heat the water in a kettle.
  • Boiling water must be poured right away into the drain hole
  • Switch on the faucet and examine to see if the water drains smoothly. If it is still draining slowly or standing still in the sink, repeat the technique.

Very important: Do not try this technique if your drain is connected to PVC pipelines, as the boiling water might melt or harm the plastic.

 

If the boiling water fails to clear the obstruction on the 2nd try, it’s time to try another technique. Unfortunately, you have a sink obstruction that is tough to the simple boiling water service.

Some jobs are better left to the pros

Sink still not draining? Get No-Commitment Estimates!

2. Check the garbage disposal

If you have a garbage disposal in your sink, it could be the source of your drain issues. If the obstruction remains in the garbage disposal, turning it on will normally break it apart.

 

Overheated or defective disposals might not even turn on, however you might easily reboot them by pushing the reset switch on the side or bottom of the machine. After resetting the disposal, restart it to clear the obstruction.

 

When you turn on the disposal, you might hear a low humming noise, which shows that the machine is jammed or malfunctioning. Before trying to fix your disposal, remember to shut off the electricity and never– and we imply never– insert your hand in the disposal.

 

You can then try to separate the obstruction in the disposal by manually turning the blades. Place an Allen wrench into the opening on the bottom of the disposal and twist up until you feel less resistance, indicating that the blockage is breaking apart.

3. Plunge away the blockage

It’s time to pull out the plunger as soon as you have actually validated that the garbage disposal isn’t the problem. But bear in mind that, while you can utilize a toilet plunger if that’s all you have, Expert Plumbing services suggest utilizing a flat-bottomed one for the job.

 

With the plunger in hand, follow the following tasks:

 

  • Fill the sink with hot water up until it’s midway full, forming a seal around the drain.
  • Place the plunger over the drain and rapidly pump up and down a number of times.
  • See and remove the plunger whether or not the water drains.
  • Repeat this action up until the water drains freely.

You know what to do if the sink is still not draining correctly after several plunging efforts. It’s time to try our next technique.

4. Break it down with baking soda and vinegar

This technique is a more natural option to utilizing chemical drain cleaners in order to unclog drains. Baking soda and vinegar are more normal house products that you are likely to have in your kitchen area.

 

To enable the mixture to perform its magic, follow these actions:

 

  • Utilizing a cup or bowl, dispose of any standing water from the sink.
  • Pour 1 cup of baking soda down the drain, pushing the powder down with a spatula or spoon if required.
  • 1 cup of white vinegar ought to be poured down the drain.
  • Seal the drain opening with a stopper or cover.
  • Permit the mixture to rest for 15 minutes.
  • Take out the cap and flush the drain with hot water.

This natural approach, like any other unclogging technique, does not guarantee success. If, after finishing the actions, it looks like you are making progress on the obstruction, repeat the actions.

5. Try the plumber’s snake

Clogs that fight back will require making use of a plumber’s snake to clear the obstruction. The tool has a spiral snake that is coiled and reaches down into the drain. When the snake comes into contact with a clog, crank the handle to break the trash and draw it out of the drain.

 

Electric snakes have even greater power to unclog drains.

 

You can make one out of a wire coat hanger if you do not have a plumber’s snake. Just simply unwind the hanger into a long strand of wire with a pair of needle-nose pliers.

 

Keep the hooked end as it will be used to grab onto the clutter. If required, utilize the pliers to customize the hook’s angle so that it fits easily into the drain opening.

 

Whatever tool you’re utilizing, just feed it a couple of feet at a time down the drain. You might accidentally push the obstruction further down the pipeline if you push too hard.

 

When the tip of your tool comes into contact with a blockage, hook it on and drag the clutter up into the drain.

6. Clean the P-trap

Sink P-Trap Diagram Plumbing

If the water still does not drain easily, there could be a blockage in the P-trap, which is the elbow-shaped pipe under your sink. Food, grease, and other debris might become stuck in the pipeline, causing your sink to drain gradually or not at all as the water meets a snag on its way down.

 

The idea is to take off the pipeline and clear away the stuff that is blocking it. Caution: This job can get a little messy, so arm yourself with safety glasses, gloves, and towels.

When you’re ready, clear the P-trap as follows:
  • Put a pail under the pipe. This will collect any backed-up water or dirt that might fall out when the P-trap is opened.
  • Loosen the trap connections that connect the curved piece to the horizontal and vertical drain pipelines. On either end of the P-trap, a slip nut ought to be present.
  • Remove the P-trap and scrub the pipe of any grime, residue, or dirt.
  • Reattach the trap. Switch on the faucet to clear the drain.

If the drain problem is still bad, the block could be further up the pipeline. You go back under the sink to identify the source of the obstruction.

Here’s what you want to do:
  • Repeat the process that takes off the P-trap.
  • The horizontal pipe that connects the system to the wall need to be removed.
  • Get in the wall pipe with a plumber’s coat, snake, or auger hanger. When you find a clog, utilize your tool to remove it from the pipe.
  • Repeat the procedure up until all debris has actually been removed.
  • Reassemble the pipelines and P-trap by hand tightening the connections. (A note of caution: Do not overtighten, as this might trigger the connections to damage).
  • Flush the drain with hot water.
  • Check under the sink while the water is running to make certain there isn’t any dripping from the pipelines even before you rejoice in your success.

If you do see leakages, confirm that all connections are securely connected. Once you’re free of the drips, just dry any water spilled from under the sink or on the floor, and you’re ready to go.

If you have actually gotten this far and your sink is still not draining, there could be a greater problem at hand. It’s time to give up and schedule an appointment with a plumber for a professional repair work.

How to prevent future clogs

Now that your kitchen’s sink is draining correctly once again, make sure you’re acting to lower future clogs. The most essential preventative measure is to prevent flushing harmful products down the drain.

 

This includes the following:
  • Grease, fats, and oils
  • Meats
  • Coffee grounds
  • Eggshells
  • Starchy foods, such as pasta, bread, or rice
  • Fruit peels, pits
  • Gum
  • Paint
  • Paper products, such as paper towels or food wrappers

Rather, pour frying oil into an old can and throw it after it’s filled. Certain waste, such as coffee grounds, can be added to mulch or organic waste.

 

Plumbers additionally advises that house owners not overload their waste disposal unit. Avoid grinding more than one cup of food waste at a time, and, obviously, prevent getting rid of any of the above products.

 

Another excellent upkeep suggestion is to make an equal mixture of vinegar and water and freeze it in an ice cube tray.

 

Grind a handful of the cubes down your waste disposal unit once a month to scrape away food waste and keep the unit clear.

 

Running boiling water down the drain after each sink use is another wise practice for the advantage of your pipelines. You ought to additionally utilize a drain cover to trap debris before it leads to damage to the pipelines.

 

While clogged drains are a simple DIY task, being gotten ready for significant plumbing issues before they happen is always a wise plan.

Some jobs are better left to the pros...

Consult a Pro. Get No-Commitment Estimates For Your Project.

Proud to Install, Repair, and Service the Following Brands: